Re: machine rethink
Posted by
krashking405
on 2006-06-17 07:00:54 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "turbulatordude"
<dave_mucha@...> wrote:
any motors is most likely going to be out of the question. I'm
planning on building my own controller, have one I'm looking at that
should cost me about $30 in material and parts.
<dave_mucha@...> wrote:
>parts
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "krashking405"
> <krashking405@> wrote:
> >
> > I've decided to change from making a machine that would handle
> > up to 12" square down to something that will handle max sizedpart of
> > about 4" square. My steppers are rated at 24V, other than speed,why
> > wouldn't I be able to run these at 12v?pretty
> >
>
> The question is not IF you can. but what is gained or lost ?
>
> If you check out MPJA, they have some nice NEMA23, double stack
> cheap.you
>
> What do you want to do with the machine ? speed is not all that
> important on a small machine, but power is. if you use pulleys,
> can get more delivered power on the screw. Also, on that sizemachine,
> a 1/4-28 stainless screw from McMaster will be less than $5.00 IThat leadscrew sounds good, but my budget is so small that buying
> think. more TPI means even more delivered power.
>
> Dave
>
any motors is most likely going to be out of the question. I'm
planning on building my own controller, have one I'm looking at that
should cost me about $30 in material and parts.
Discussion Thread
krashking405
2006-06-16 17:14:17 UTC
machine rethink
turbulatordude
2006-06-16 21:19:07 UTC
Re: machine rethink
Paul Kelly
2006-06-16 21:58:07 UTC
RE: [CAD_CAM_EDM_DRO] Re: machine rethink
Graham Stabler
2006-06-17 04:20:36 UTC
Re: machine rethink
krashking405
2006-06-17 07:00:54 UTC
Re: machine rethink