Re: [CAD_CAM_EDM_DRO] Screw cutting - Was: Lathe controller about micrtokinetics

----- Original Message -----
From: Paul Corner <Paul.Corner@...>
Date: Wednesday, July 12, 2000 2:18 am
Subject: Re: [CAD_CAM_EDM_DRO] Screw cutting - Was: Lathe controller
about micrtokinetics

>Dear PAUL,

There is some misunderstanding.

The optistep card mfg. by microkinetics is not able to thread at rpm's
crossing 1000 to 1100 rpm.

You are correct most lathes thread very well at around 1500rpm. One
needs good rpm's especially for threading aluminium

regards

Byron Damania


> </tt>
>
> <!-- |**|begin egp html banner|**| -->
>
>
> <hr>
> <!-- |@|begin eGroups banner|@| runid: 6636 crid: 1589 -->
> <center>
> <img width="468" height="60"
> border="0"
> alt=""
> src="http:</center><center><font color="black"></font></center>
> <!-- |@|end eGroups banner|@| -->
> <hr>
>
> <!-- |**|end egp html banner|**| -->
>
> <tt>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
>
>
> Addresses:
>
> Post message: CAD_CAM_EDM_DRO@egroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>
> Moderator: jmelson@... [Moderator]
>
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> bill,
>
> List Manager</tt>
>
>
>
> </body></html>
>
>