Re: [CAD_CAM_EDM_DRO] Re: water jet cam
Posted by
Les Newell
on 2006-09-01 05:46:09 UTC
SheetCam <www.sheetcam.com> can do this at a much lower price. I can
write a post processor for you that will slow down to a preset
percentage of the normal feed rate on arcs. The post could even be
configured to slow down more for tighter arcs.
Les
write a post processor for you that will slow down to a preset
percentage of the normal feed rate on arcs. The post could even be
configured to slow down more for tighter arcs.
Les
> afogassa wrote:
>
>> Hi Peter,
>> I do have deskcnc and it's good enough for this, but water jets
>> needs a good cam that can look way ahead and predicts what is going
>> to happen and than starts to adjust the feed rate before it gets to
>> a corner or radius to compensate for Jet lag doing that manualy
>> would be a pain if not impossible.
>> Got a quote from PEPs and it runs at 10K US$ (ouch !!)
>> I've being thinking about getting a working G code, than work this
>> out on excel to adjust the feed rate.
>>
Discussion Thread
afogassa
2006-08-30 17:17:23 UTC
water jet cam
Peter Renolds
2006-08-31 09:11:50 UTC
Re: [CAD_CAM_EDM_DRO] water jet cam
afogassa
2006-08-31 13:09:23 UTC
Re: water jet cam
Jon Elson
2006-08-31 15:44:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: water jet cam
Les Newell
2006-09-01 05:46:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: water jet cam
John Dammeyer
2006-09-01 07:52:26 UTC
RE: [CAD_CAM_EDM_DRO] Re: water jet cam
Les Newell
2006-09-01 08:38:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: water jet cam
John Dammeyer
2006-09-01 09:09:27 UTC
RE: [CAD_CAM_EDM_DRO] Re: water jet cam
Les Newell
2006-09-01 09:32:25 UTC
Re: [CAD_CAM_EDM_DRO] Re: water jet cam
afogassa
2006-09-01 18:30:12 UTC
Re: water jet cam