CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: water jet cam

Posted by Les Newell
on 2006-09-01 08:38:17 UTC
Hi John,

SheetCam is a CAM package so it takes your drawing, works out the
toolpaths, cut order etc then generates G-code for Mach to cut.

For instance say you draw a 1" square. You could load that drawing into
Mach and cut it but Mach would follow the lines exactly so the part
would come out undersized by the cutter diameter. SheetCam knows about
this so it would increase the size of the square to allow for the cutter
diameter. Your part would now come out exactly to size.

Les


John Dammeyer wrote:
> I See from the web site that the registration tab can include MACH2. So why
> would someone need sheetcam if they have MACH2/3?
>
> John Dammeyer
>
>> Subject: Re: [CAD_CAM_EDM_DRO] Re: water jet cam
>>
>>
>> SheetCam <www.sheetcam.com> can do this at a much lower price. I can
>> write a post processor for you that will slow down to a preset
>> percentage of the normal feed rate on arcs. The post could even be
>> configured to slow down more for tighter arcs.
>>
>> Les
>>

Discussion Thread

afogassa 2006-08-30 17:17:23 UTC water jet cam Peter Renolds 2006-08-31 09:11:50 UTC Re: [CAD_CAM_EDM_DRO] water jet cam afogassa 2006-08-31 13:09:23 UTC Re: water jet cam Jon Elson 2006-08-31 15:44:18 UTC Re: [CAD_CAM_EDM_DRO] Re: water jet cam Les Newell 2006-09-01 05:46:09 UTC Re: [CAD_CAM_EDM_DRO] Re: water jet cam John Dammeyer 2006-09-01 07:52:26 UTC RE: [CAD_CAM_EDM_DRO] Re: water jet cam Les Newell 2006-09-01 08:38:17 UTC Re: [CAD_CAM_EDM_DRO] Re: water jet cam John Dammeyer 2006-09-01 09:09:27 UTC RE: [CAD_CAM_EDM_DRO] Re: water jet cam Les Newell 2006-09-01 09:32:25 UTC Re: [CAD_CAM_EDM_DRO] Re: water jet cam afogassa 2006-09-01 18:30:12 UTC Re: water jet cam