Gecko matched servomotors with US Digital encoders
Posted by
rllalonde2000
on 2006-09-09 03:23:53 UTC
Hi all, Rick from HomeshopCNC here. A while back I asked Mariss to call
out specs for a MCG type servo in order to get a good match to G320 &
340. The motors I ordered on that basis are here now and we mount 250
or 500 CPR encoders from USD on them. These are nema 34 with skewed
rotors for low cogging.
I've been to the factory and believe in the performance/longevity of
these servos. We also offer Geckos at a great price if you get one with
a motor. See www.homeshopcnc.com
-Rick L.
out specs for a MCG type servo in order to get a good match to G320 &
340. The motors I ordered on that basis are here now and we mount 250
or 500 CPR encoders from USD on them. These are nema 34 with skewed
rotors for low cogging.
I've been to the factory and believe in the performance/longevity of
these servos. We also offer Geckos at a great price if you get one with
a motor. See www.homeshopcnc.com
-Rick L.
Discussion Thread
rllalonde2000
2006-09-09 03:23:53 UTC
Gecko matched servomotors with US Digital encoders
Mike Richards
2006-09-10 11:09:19 UTC
Re: Gecko matched servomotors with US Digital encoders
rllalonde2000
2006-09-12 00:42:46 UTC
Re: Gecko matched servomotors with US Digital encoders
KelingInc
2006-09-22 18:14:06 UTC
SERVO Motor with US Digital Encoder