Re: [CAD_CAM_EDM_DRO] encoder wiring

In a message dated 9/16/2006 3:35:38 P.M. Eastern Daylight Time,
rocketscientistnate@... writes:

I can't seem to get any response from centroid. Is there any kind of
tests I can do to figure out the wiring of this motor/encoder? All I
can see is 3 heavy wires (such as for power) on one plug, and nine
light ones on the other. They had a prewire kit that seems to have a
9 pin d-connector on the end. Is this a universal wiring scheme for
quarature encoders? would that be wired for my rutex driver or only
centroids drivers?

Thanks
Nathan



The larger wires would be for power to the motor I am sure. The pin-out for
the encoder is not always uniform from one manufacturer to the other and
neither are the configuration of the connectors. Can you E-mail me all of the
information off of the encoder and motor. I may have some sources that can
help with that.

Randy



Randy Abernathy
4626 Old Stilesboro Road NW
Acworth, GA 30101-4066
E-mail: cnc002@...

I furnish technical support, repair, and other related services for your
industrial woodworking machinery. My background as Senior Service Engineer for
the SCMI Group for nearly fifteen years with factory training, combines with
my extensive background in electronics, mechanics, pneumatics, electrical and
CNC machinery to offer you needed support for your machinery. Services
include but are not limited to the following:


[Non-text portions of this message have been removed]