CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Is my SMALL plasma table idea nuts?

Posted by Tony Smith
on 2006-10-23 12:35:35 UTC
> Since I have limited space I am considering making a small
> plasma table that sits ON the metal sheet to be cut. I
> already have a small cutting table and ventilation system for
> my Powermax 600 and thought a small (maybe 2' X 3') table
> might be fine for my art. If I wanted to cut larger pieces I
> would cut the graphic into pieces in the cad program, make
> piece-meal g-code and move the table around the sheet of
> metal. Since it would be small the alignment issues and cost
> would be reduced significantly too.
>
> Is this idea nuts?


That's a bit like those magnetic drills.

Like a drill press, but an electromagnet in the base. Place on metal, turn
on magnet, drill hole, turn off magnet, repeat.

You actually don't need a lot of power to make the electromagnet work.

So long as the table is lighter than what you're cutting, why not?

Tony

Discussion Thread

William Meincer 2006-10-23 11:35:32 UTC Is my SMALL plasma table idea nuts? Tony Smith 2006-10-23 12:35:35 UTC RE: [CAD_CAM_EDM_DRO] Is my SMALL plasma table idea nuts? Victor A. Estes 2006-10-23 12:39:34 UTC Re: [CAD_CAM_EDM_DRO] Is my SMALL plasma table idea nuts? turbulatordude 2006-10-23 12:50:46 UTC Re: Is my SMALL plasma table idea nuts? William Meincer 2006-10-23 14:59:55 UTC Re: Is my SMALL plasma table idea nuts? caudlet 2006-10-23 15:04:47 UTC Re: Is my SMALL plasma table idea nuts? Paul Kelly 2006-10-23 15:11:41 UTC RE: [CAD_CAM_EDM_DRO] Re: Is my SMALL plasma table idea nuts? caudlet 2006-10-23 15:27:25 UTC Re: Is my SMALL plasma table idea nuts? William Meincer 2006-10-23 16:49:37 UTC Re: Is my SMALL plasma table idea nuts? Darren Lucke 2006-10-23 17:30:48 UTC Re: [CAD_CAM_EDM_DRO] Re: Is my SMALL plasma table idea nuts? William Meincer 2006-10-24 05:45:14 UTC Re: Is my SMALL plasma table idea nuts? David A. Frantz 2006-10-25 09:48:16 UTC Re: [CAD_CAM_EDM_DRO] Re: Is my SMALL plasma table idea nuts?