Re: Timing Belts and Pulleys

> >
> OK, if W. M. Berg, Stock Drive Produts/Sterling Instrument and McMaster
> Carr are out, where
> do you get YOUR pulleys from? I'm not quibbling about a couple
> thousandths of an inch, that
> is certainly acceptable for this use, but when you can see the
> eccentricity, that's pretty bad.
> Not all of them are that bad, however.
>
> Jon
>

I open the phone book.

I found my local distributor was within 10% of those guys on-line.

It does require me to get in my car and go for a ride, but I can get
it in a few hours.

There are a few guys listed in the yellow pages, so I have choices.
They all will send them out UPS, and most take credit cards.

If I go to the store, I can also inspect it and get one that is good.

Dave