CAD CAM EDM DRO - Yahoo Group Archive

Re: Image to DXF Converter & DXF to G-Code Converter

Posted by John Hansford
on 2006-12-10 19:55:17 UTC
Hi Anne,

I don't know about I_Deas, but the easiest software I've found is
here....

http://www.vectric.com/WebSite/Vectric/vcp/vcp_index.htm

I use it for many other things than signs.

You can make your own Post Processor also.


John


--- In CAD_CAM_EDM_DRO@yahoogroups.com, "eng8248" <eng8248@...> wrote:
>
> I am in the research process of building a CNC Plasma Cutter. From a
> Software aspect, I need a software to convert an image file, such as
> JPEG or BMP, into a DXF file to be inputted into I_Deas CAD software.
> I am also in need of a software that converts a DXF file into G&M Code
> to be inputted into the controller. I wasn't sure if there's such a
> software available, or will I have to write a post-processor to do the
> job for me? Cost is not an issue at the moment, because I am currently
> just comparing different software packages.
> I'd appreciate any suggestions or personal experiences.
> Anne
>

Discussion Thread

eng8248 2006-12-10 19:22:43 UTC Image to DXF Converter & DXF to G-Code Converter John Hansford 2006-12-10 19:55:17 UTC Re: Image to DXF Converter & DXF to G-Code Converter turbulatordude 2006-12-10 20:36:26 UTC Re: Image to DXF Converter & DXF to G-Code Converter Lester Caine 2006-12-10 23:58:49 UTC Re: [CAD_CAM_EDM_DRO] Re: Image to DXF Converter & DXF to G-Code Converter caudlet 2006-12-11 07:42:01 UTC Re: Image to DXF Converter & DXF to G-Code Converter al5502 2006-12-11 11:45:38 UTC Re: Image to DXF Converter & DXF to G-Code Converter