Re: [CAD_CAM_EDM_DRO] Parallel port isolation
Posted by
Ejay Hire
on 2000-07-20 13:00:45 UTC
Output Only:
(2) 4 per package DIP optoisolators
(2) IC Sockets
(1) 6 Volt DC 900ma power supply
(1) Randomly selected small filter cap
(1) 25-Pin D connector
(1) 12 position Screw Terminal Block (8 Outputs, 4 Ground Terminals)
(1) Case
Do you want one built?
Do you need Inputs?
----Original Message Follows----
From: Ron Ginger <ginger@...>
Reply-To: CAD_CAM_EDM_DRO@egroups.com
To: "CAD_CAM_EDM_DRO@onelist.com" <CAD_CAM_EDM_DRO@egroups.com>
Subject: [CAD_CAM_EDM_DRO] Parallel port isolation
Date: Thu, 20 Jul 2000 13:20:31 -0400
A while back there was a lot of discussion here about building a module
to isolate a PC parallel port. Did any thing ever come form that? I
recall someone was going to offer a board for this.
What I want is a little box to plug into the PC, maybe on a short cable
or direct into the back of the PC, and have screw terminals on it for me
to hookup to my driver board. Anyone build such a box.
ron
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
(2) 4 per package DIP optoisolators
(2) IC Sockets
(1) 6 Volt DC 900ma power supply
(1) Randomly selected small filter cap
(1) 25-Pin D connector
(1) 12 position Screw Terminal Block (8 Outputs, 4 Ground Terminals)
(1) Case
Do you want one built?
Do you need Inputs?
----Original Message Follows----
From: Ron Ginger <ginger@...>
Reply-To: CAD_CAM_EDM_DRO@egroups.com
To: "CAD_CAM_EDM_DRO@onelist.com" <CAD_CAM_EDM_DRO@egroups.com>
Subject: [CAD_CAM_EDM_DRO] Parallel port isolation
Date: Thu, 20 Jul 2000 13:20:31 -0400
A while back there was a lot of discussion here about building a module
to isolate a PC parallel port. Did any thing ever come form that? I
recall someone was going to offer a board for this.
What I want is a little box to plug into the PC, maybe on a short cable
or direct into the back of the PC, and have screw terminals on it for me
to hookup to my driver board. Anyone build such a box.
ron
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
Discussion Thread
Ejay Hire
2000-07-20 13:00:45 UTC
Re: [CAD_CAM_EDM_DRO] Parallel port isolation
Doug Harrison
2000-07-20 13:45:22 UTC
Re: [CAD_CAM_EDM_DRO] Parallel port isolation
Paul Devey
2000-07-20 13:54:47 UTC
Re: [CAD_CAM_EDM_DRO] Parallel port isolation
Ron Ginger
2000-07-21 07:21:12 UTC
Re: [CAD_CAM_EDM_DRO] Parallel port isolation
Doug Harrison
2000-07-21 13:32:11 UTC
Re: [CAD_CAM_EDM_DRO] Parallel port isolation