RE: [CAD_CAM_EDM_DRO] Project on a miniscule budget

He did say a square bar.

______________________________________
Andy Wander | Vice President, Engineering
Verrex


-----Original Message-----
From: CAD_CAM_EDM_DRO@yahoogroups.com [mailto:CAD_CAM_EDM_DRO@yahoogroups.com] On Behalf Of R Wink
Sent: Thursday, February 15, 2007 10:22 AM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: RE: [CAD_CAM_EDM_DRO] Project on a miniscule budget

First off, a .1875 square will not fit inside of a .250 diameter, lapped or
otherwise.

After that you might try Reid Tool Supply: HYPERLINK
"https://reidecom.reidtool.com/xephr/edit/ITEM_GROUP_DETAIL?query=*CATALOG_I
D=RF118&query=*ITEM_NO=SHS-18&query=*GROUP_ID=100583&query=*START_WITH_ID=10
0583"https://reidecom.reidtool.com/xephr/edit/ITEM_GROUP_DETAIL?query=*CATAL
OG_ID=RF118&query=*ITEM_NO=SHS-18&query=*GROUP_ID=100583&query=*START_WITH_I
D=100583

Where you'll find a .3125 diameter with a .1915 square sleeve, 1 ½ inches
long for $10.35 USD.

R. Wink



_____

From: CAD_CAM_EDM_DRO@yahoogroups.com
[mailto:CAD_CAM_EDM_DRO@yahoogroups.com] On Behalf Of milespaul2004
Sent: Thursday, February 15, 2007 7:05 AM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Project on a miniscule budget



Here's one to challenge all of you!

I need to put a 0.1875" square hole along a 1.25 inch length of a
0.250" square BMS bar. I need this hole to be a lapped or precision
fit on 0.1875" square bronze slipper. Fabrication using silver
soldered joints is a possibility but so far I have not been able to
produce these components with the fine finish I need for the job...
An EDM machine came to mind and I would like to have a go at making a
simple one if that's possible.
I am retired here in the UK and have little spare cash but as an ex
audio engineer and film sound recordist I do have some knowledge of
electronics.
I know there was a circuit for a very simple machine in Model
Engineer magazine many years ago (1970's I think) but tracking the
issue and a copy down has been fruitless so far even through the now
owners of the publication.
I believe the designers name was Roy Amsbury who worked for Rolls
Royce in Derby but I have been told he passed away some years ago.
Just wondered if anyone has a simple EDM machine design that they
might be prepared to let me have. Could be an interesting project to
pass the time away with.
Regards to all
Paul Miles.




This communication including any attachments, are intended
for the exclusive use of the addressee(s) and contains
confidential or copyrighted materials. Duplication,
distribution or reproduction is strictly prohibited by law
without written permission of Verrex