CAD CAM EDM DRO - Yahoo Group Archive

Re: Gecko Support / Motor Spec.

on 2007-06-03 21:54:19 UTC
Hi All,

I've got this Fanuc yellow cap 20M (23Nm TRQ, 18 Amp, 213V 1500RPM)
DC brush motor . I'm driving it with onther brand drive (Rutex R2020)
never burning the 10 amp fuse !

Is there any way I can drive it by the G320?
Thanks,
Shadi Salhab






--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Bob Campbell" <bob@...> wrote:
>
> Shadi,
>
> Mariss is very good about answering email. Just be patient as he is
very busy.
>
> You can also ask the group about your motor.
>
> Robert Colin Campbell
> Bob Campbell Designs
> www.Campbelldesigns.net
> Mach 2/3 breakout boards
> Relay boards
> Spindle Speed boards
> Stepper motors
> Plasma Torch Height control
> ----- Original Message -----
> From: shadi_salhab_78
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Sent: Sunday, June 03, 2007 11:35 AM
> Subject: [CAD_CAM_EDM_DRO] Gecko Support Email
>
>
> Hi all,
> I've send an email to gecko company asking for motor compatibality ,
> but no answer ! Is this always the case ? How can contact them ?
> Thanks,
> Shadi Salhab
>
>
>
>
>
> [Non-text portions of this message have been removed]
>

Discussion Thread

shadi_salhab_78 2007-06-03 09:40:02 UTC Gecko Support Email Bob Campbell 2007-06-03 11:57:39 UTC Re: [CAD_CAM_EDM_DRO] Gecko Support Email shadi_salhab_78 2007-06-03 21:54:19 UTC Re: Gecko Support / Motor Spec. R Rogers 2007-06-03 22:37:14 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko Support / Motor Spec. Jon Elson 2007-06-04 10:22:27 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko Support / Motor Spec. shadi_salhab_78 2007-06-05 21:12:29 UTC Re: Gecko Support / Motor Spec. David G. LeVine 2007-06-05 21:59:38 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko Support / Motor Spec. Jon Elson 2007-06-06 10:04:41 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko Support / Motor Spec.