Re: Gecko Support / Motor Spec.
Posted by
shadi_salhab_78
on 2007-06-05 21:12:29 UTC
Hi all,
I think I have to accepte the 500 RPM ! According to gecko : is it a
must to have the opto-isolated step input or I can drive it directly
from compurt parralel port ?
Thanks,
Shadi
I think I have to accepte the 500 RPM ! According to gecko : is it a
must to have the opto-isolated step input or I can drive it directly
from compurt parralel port ?
Thanks,
Shadi
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Jon Elson <elson@...> wrote:
>
> shadi_salhab_78 wrote:
> > Hi All,
> >
> > I've got this Fanuc yellow cap 20M (23Nm TRQ, 18 Amp, 213V 1500RPM)
> > DC brush motor . I'm driving it with onther brand drive (Rutex R2020)
> > never burning the 10 amp fuse !
> >
> > Is there any way I can drive it by the G320?
> You can, but the top speed will be 80/213 * 1500 = 563 RPM. If
> that is enough for you, then fine, otherwise another make of
> drive is the only way.
>
> Jon
>
Discussion Thread
shadi_salhab_78
2007-06-03 09:40:02 UTC
Gecko Support Email
Bob Campbell
2007-06-03 11:57:39 UTC
Re: [CAD_CAM_EDM_DRO] Gecko Support Email
shadi_salhab_78
2007-06-03 21:54:19 UTC
Re: Gecko Support / Motor Spec.
R Rogers
2007-06-03 22:37:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Support / Motor Spec.
Jon Elson
2007-06-04 10:22:27 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Support / Motor Spec.
shadi_salhab_78
2007-06-05 21:12:29 UTC
Re: Gecko Support / Motor Spec.
David G. LeVine
2007-06-05 21:59:38 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Support / Motor Spec.
Jon Elson
2007-06-06 10:04:41 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko Support / Motor Spec.