CAD CAM EDM DRO - Yahoo Group Archive

Re: 3d printer first step

on 2007-06-12 05:40:45 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "afogassa" <afogassa@...> wrote:

> -Large motor just returns the gantry, after printing is done gantry
> moves back as if it was taking the paper out of the printer, there is
> a aluminum L shaped there to tell the printer the paper still on it
> till when it is near the big motor then it stops, hit a switch and
> it's back to the beginning.

How does the printer drive itself when printing? Why does this
mechanism not inhibit the return mechanism? Are you just back driving it?

Graham

Discussion Thread

afogassa 2007-06-11 07:26:02 UTC 3d printer first step Graham Stabler 2007-06-11 07:49:14 UTC Re: 3d printer first step afogassa 2007-06-11 07:53:01 UTC Re: 3d printer first step afogassa 2007-06-11 18:31:29 UTC 3d printer first step Dan Mauch 2007-06-11 20:14:50 UTC Re: [CAD_CAM_EDM_DRO] 3d printer first step Graham Stabler 2007-06-12 03:07:01 UTC Re: 3d printer first step afogassa 2007-06-12 04:53:01 UTC Re: 3d printer first step afogassa 2007-06-12 05:00:59 UTC Re: 3d printer first step Graham Stabler 2007-06-12 05:40:45 UTC Re: 3d printer first step afogassa 2007-06-12 06:15:46 UTC Re: 3d printer first step Mark Bingham 2007-06-12 06:46:45 UTC Re: [CAD_CAM_EDM_DRO] 3d printer first step Graham Stabler 2007-06-12 07:28:36 UTC Re: 3d printer first step Graham Stabler 2007-06-12 07:30:19 UTC Re: 3d printer first step afogassa 2007-06-12 07:55:30 UTC Re: 3d printer first step Graham Stabler 2007-06-12 13:33:25 UTC Re: 3d printer first step afogassa 2007-06-12 16:23:45 UTC Re: 3d printer first step Graham Stabler 2007-06-12 16:45:20 UTC Re: 3d printer first step dandumit 2007-06-14 02:05:02 UTC Re: 3d printer first step afogassa 2007-06-14 08:29:58 UTC Re: 3d printer first step