CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Air Cylinder Press

Posted by John Grant
on 2000-07-30 07:59:37 UTC
Jim Register wrote:
>
> At 02:40 PM 7/29/2000 EDT, Mario wrote:
> >Anyone has any plans for a small table top air cylinder press?
>
> You really do not want to use air to power a press. Imagine pressing a bearing off a shaft. Once the parts separate, there is nothing to restrain the air cylinder from flying to its fully extended position - except maybe fingers and toes. The impact at the end of travel will not be good for things either.

If you are using a double acting cylinder, there is the air on the other
side of the piston to slow things down.

John Grant

Discussion Thread

MIADSGNS@a... 2000-07-29 11:40:23 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press Tim Goldstein 2000-07-29 11:50:04 UTC RE: [CAD_CAM_EDM_DRO] Air Cylinder Press ptengin@a... 2000-07-29 13:10:43 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press Jim Register 2000-07-29 19:20:11 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press Derek B. 2000-07-29 19:49:04 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press JanRwl@A... 2000-07-29 19:54:51 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press dave engvall 2000-07-29 20:05:49 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press JanRwl@A... 2000-07-29 20:11:49 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press Bertho Boman 2000-07-29 21:28:11 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press MIADSGNS@a... 2000-07-29 22:28:22 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press ptengin@a... 2000-07-30 03:46:03 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press George Potter 2000-07-30 07:20:25 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press John Grant 2000-07-30 07:59:37 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press John Grant 2000-07-30 08:06:03 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press John Grant 2000-07-30 08:10:57 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press John Grant 2000-07-30 08:30:22 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press Jim Register 2000-07-30 12:01:33 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press John Grant 2000-07-30 16:37:30 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press Jon Anderson 2000-07-30 18:13:32 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press ptengin@a... 2000-07-31 02:22:02 UTC Re: [CAD_CAM_EDM_DRO] Air Cylinder Press