Re: [CAD_CAM_EDM_DRO] Syil America Mill???
Posted by
Jon Elson
on 2007-07-26 09:50:56 UTC
George Taylor, IV wrote:
board drilling machine. They most likey would cost over $5000
each, today. No need for such stuff on a Bridgeport, but the
machine was being scrapped, and I got them for a song. The
"drive" assembly is a 2.5:1 belt reduction that was on the PC
drill, I just made adaptors to fit them to the Bridgeport.
The servo amplifiers are my own design, and I made them
available as a kit for a while, but I don't think anyone built
them, other than me. They do work pretty well, though. The
motors are 1950's technology GE shunt-field brush motors, 1/8 Hp
continuous, and were quite adequate for driving the 10 Lb table
on the PC board drill. They are marginal on the Bridgeport, but
I'm not complaining.
I can do 120 IPM, but actually limit it in the software to 90
IPM, and never go over 60 because I start having crashes. The
machine is obviously faster than my reaction time!
Jon
> Jon,I got a set of ground precision high-accuracy screws out of a PC
>
> What ballscrews, drives and motors do you use on your Bport? What kind
> of rapids are you able to achieve?
board drilling machine. They most likey would cost over $5000
each, today. No need for such stuff on a Bridgeport, but the
machine was being scrapped, and I got them for a song. The
"drive" assembly is a 2.5:1 belt reduction that was on the PC
drill, I just made adaptors to fit them to the Bridgeport.
The servo amplifiers are my own design, and I made them
available as a kit for a while, but I don't think anyone built
them, other than me. They do work pretty well, though. The
motors are 1950's technology GE shunt-field brush motors, 1/8 Hp
continuous, and were quite adequate for driving the 10 Lb table
on the PC board drill. They are marginal on the Bridgeport, but
I'm not complaining.
I can do 120 IPM, but actually limit it in the software to 90
IPM, and never go over 60 because I start having crashes. The
machine is obviously faster than my reaction time!
Jon
Discussion Thread
Jack Mc Kie
2007-07-25 09:41:46 UTC
Syil America Mill???
Jon Elson
2007-07-25 20:38:21 UTC
Re: [CAD_CAM_EDM_DRO] Syil America Mill???
George Taylor, IV
2007-07-25 23:10:14 UTC
RE: [CAD_CAM_EDM_DRO] Syil America Mill???
Russell Dunn
2007-07-26 04:37:38 UTC
Re:Syil America Mill???
Jon Elson
2007-07-26 09:50:56 UTC
Re: [CAD_CAM_EDM_DRO] Syil America Mill???
Jack Mc Kie
2007-07-26 10:03:28 UTC
Re: Syil America Mill???
Jon Elson
2007-07-26 19:26:08 UTC
Re: [CAD_CAM_EDM_DRO] Re: Syil America Mill???