Re: Dual shaft dc motor supplier
Posted by
caudlet
on 2007-08-04 20:47:54 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "kstropus" <kstropus@...> wrote:
real hard.
You might want to pop over to CNCZone and do some light reading in the
DIY servo Controller thread.
>all you have to do to make a diamond is find some coal and squeeze it
>> All I have to do with a servo controller (it seems to me) is move it
> forward or reverse until I count the steps I need then keep it there.
real hard.
You might want to pop over to CNCZone and do some light reading in the
DIY servo Controller thread.
Discussion Thread
kstropus
2007-08-03 17:49:40 UTC
Dual shaft dc motor supplier
Andrey Lipavsky
2007-08-03 23:12:01 UTC
RE: [CAD_CAM_EDM_DRO] Dual shaft dc motor supplier
Bill
2007-08-04 09:08:09 UTC
Re: Dual shaft dc motor supplier
kstropus
2007-08-04 14:17:40 UTC
Re: Dual shaft dc motor supplier
kstropus
2007-08-04 14:19:49 UTC
Re: Dual shaft dc motor supplier
caudlet
2007-08-04 20:47:54 UTC
Re: Dual shaft dc motor supplier
Bill
2007-08-04 20:48:52 UTC
Re: Dual shaft dc motor supplier
Andrey Lipavsky
2007-08-04 23:10:07 UTC
RE: [CAD_CAM_EDM_DRO] Re: Dual shaft dc motor supplier
kstropus
2007-08-05 18:42:36 UTC
Re: Dual shaft dc motor supplier
kstropus
2007-08-05 18:45:38 UTC
Re: Dual shaft dc motor supplier
Graham Stabler
2007-08-06 03:08:52 UTC
Re: Dual shaft dc motor supplier
kstropus
2007-08-06 09:24:18 UTC
Re: Dual shaft dc motor supplier