CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Cables

Posted by Archie
on 2007-09-01 08:10:57 UTC
Actually there has been but It has been a while. run searches on
Amphenol and Moldex. and that should get you tuned in to the thread's
where this discussion is being held. there has been quite a bit of
traffic about using Balanced Microphone jacks and plugs for the encoder
connection.
Happy Hunting
archie =) =) =)

ronald_41 wrote:

> Nowhere, have I seen it listed, throughout all of the various forums on
> CNC Routers. A discussion on the pro's and con's of various cable types.
>
> Since I've purchased all of the required hardware components for my CNC
> Router project. And I've purchased a portion of the electronic
> components. I'm left with deciding how to wire up my 8-wire steppers.
>
> What type of cable end would be the best, considering that it needs to
> have a locking feature as well as strain relief? I have no desire to
> wire up the motors directly as the machine has to be portable.
>
> What would be considered the optimum in cabling considering it is
> required to provide EMF shielding, flexibility and low resistance while
> transmitting a moderately high dc voltage with a low amperage?
>
>



[Non-text portions of this message have been removed]

Discussion Thread

ronald_41 2007-09-01 00:48:17 UTC Cables ronald_41 2007-09-01 00:48:39 UTC Cables Archie 2007-09-01 08:10:57 UTC Re: [CAD_CAM_EDM_DRO] Cables Michael Fagan 2007-09-01 15:07:38 UTC Re: [CAD_CAM_EDM_DRO] Cables ronald_41 2007-09-01 17:48:25 UTC Re: Cables Michael Fagan 2007-09-01 18:06:29 UTC Re: [CAD_CAM_EDM_DRO] Re: Cables Dave Halliday 2007-09-01 22:50:20 UTC RE: [CAD_CAM_EDM_DRO] Cables David G. LeVine 2007-09-02 17:17:36 UTC RE: [CAD_CAM_EDM_DRO] Cables David G. LeVine 2007-09-02 17:20:19 UTC Re: [CAD_CAM_EDM_DRO] Re: Cables