CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Running small machine without computer

Posted by Dan Mauch
on 2007-10-16 08:51:38 UTC
It sounds like you could use a Grex G100 from www.geckodrive.com
The Grex can be programmed to make your moves using their language. As I recall there is a way to press a but and that starts the process.

Dan Mauch
economical 3D scanner software and kits
low cost stepper and servo motors.
cases for Gecko drives
kits and assembled 3-4 axis drives
www.camtronics-cnc.com
www.seanet.com/~dmauch
----- Original Message -----
From: John Hansford
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Tuesday, October 16, 2007 6:12 AM
Subject: [CAD_CAM_EDM_DRO] Running small machine without computer


Hi to All,

I'm setting up a row of 4 small desktop
routers. They'll be single purpose machines
to do the same task repeatedly and nothing
else. This will be basically milling grooves
in 1" blocks of plastic that will be no
larger than 5" x 6".

But I don't need 4 computers or want to
swap wiring...I want them all running at
the same time. Load and let run.

Where or what would I look at, as far as some
small single purpose controller for
each machine. It doesn't even need a video
monitor....just push go and let it do it's
job. Is there a small controller that could
be programmed easily with a single gcode
file or maybe a flash drive?

Thanks in advance!
John





[Non-text portions of this message have been removed]

Discussion Thread

John Hansford 2007-10-16 07:22:28 UTC Running small machine without computer hannu 2007-10-16 07:58:16 UTC Re: [CAD_CAM_EDM_DRO] Running small machine without computer Fred Smith 2007-10-16 08:33:26 UTC Re: Running small machine without computer Stephen Wille Padnos 2007-10-16 08:46:49 UTC Re: [CAD_CAM_EDM_DRO] Running small machine without computer Dan Mauch 2007-10-16 08:51:38 UTC Re: [CAD_CAM_EDM_DRO] Running small machine without computer John Hansford 2007-10-16 09:21:59 UTC Re: Running small machine without computer John Hansford 2007-10-16 09:22:12 UTC Re: Running small machine without computer hannu 2007-10-16 10:20:07 UTC Re: [CAD_CAM_EDM_DRO] Re: Running small machine without computer David G. LeVine 2007-10-16 11:34:55 UTC Re: [CAD_CAM_EDM_DRO] Running small machine without computer Jim DuBois 2007-10-16 14:45:17 UTC RE: [CAD_CAM_EDM_DRO] Running small machine without computer John Hansford 2007-10-16 16:23:02 UTC Re: Running small machine without computer John Dammeyer 2007-10-16 17:54:00 UTC RE: [CAD_CAM_EDM_DRO] Re: Running small machine without computer Fred Smith 2007-10-17 05:43:14 UTC Re: Running small machine without computer