Re: How to convert a Grizzly 1006 Mill to CNC
Posted by
vrsculptor
on 2007-10-19 14:48:08 UTC
Per,
Limit switches (NC) should be wired in series to the estop relay. If
you pass that information back to the PC thats one I/O. If you hit a
limit it should be obvious which one it is. On home switches (NO) I
have mine wired in parallel and home one axis at a time, Z, then Y
then X. Another I/O. A singe port should be fine without spindle
control. How to do spindle control is entirely dependent on which
hardware you select. A PLC may be the best answer for that.
Roger
Limit switches (NC) should be wired in series to the estop relay. If
you pass that information back to the PC thats one I/O. If you hit a
limit it should be obvious which one it is. On home switches (NO) I
have mine wired in parallel and home one axis at a time, Z, then Y
then X. Another I/O. A singe port should be fine without spindle
control. How to do spindle control is entirely dependent on which
hardware you select. A PLC may be the best answer for that.
Roger
Discussion Thread
Per Petersson
2007-10-19 14:36:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to convert a Grizzly 1006 Mill to CNC
vrsculptor
2007-10-19 14:48:08 UTC
Re: How to convert a Grizzly 1006 Mill to CNC
Per Petersson
2007-10-19 14:59:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to convert a Grizzly 1006 Mill to CNC
vrsculptor
2007-10-19 15:29:19 UTC
Re: How to convert a Grizzly 1006 Mill to CNC
David G. LeVine
2007-10-20 12:17:56 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to convert a Grizzly 1006 Mill to CNC
David G. LeVine
2007-10-20 12:21:26 UTC
Re: [CAD_CAM_EDM_DRO] Re: How to convert a Grizzly 1006 Mill to CNC