CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: How to convert a Grizzly 1006 Mill to CNC

on 2007-10-20 12:21:26 UTC
At 06:00 PM 10/19/2007, you wrote:
>I am sorry but a newbie has a hard time understand the I/O and (NC) and (NO)

I/O Input/output -- a pin on a port.

NC Normally Closed - on a switch "pushing" the actuator causes it to open.

NO Normally Open - on a switch "pushing" the actuator causes it to close.

David G. LeVine
Nashua, NH 03060

Discussion Thread

Per Petersson 2007-10-19 14:36:09 UTC Re: [CAD_CAM_EDM_DRO] Re: How to convert a Grizzly 1006 Mill to CNC vrsculptor 2007-10-19 14:48:08 UTC Re: How to convert a Grizzly 1006 Mill to CNC Per Petersson 2007-10-19 14:59:57 UTC Re: [CAD_CAM_EDM_DRO] Re: How to convert a Grizzly 1006 Mill to CNC vrsculptor 2007-10-19 15:29:19 UTC Re: How to convert a Grizzly 1006 Mill to CNC David G. LeVine 2007-10-20 12:17:56 UTC Re: [CAD_CAM_EDM_DRO] Re: How to convert a Grizzly 1006 Mill to CNC David G. LeVine 2007-10-20 12:21:26 UTC Re: [CAD_CAM_EDM_DRO] Re: How to convert a Grizzly 1006 Mill to CNC