Re: [CAD_CAM_EDM_DRO] Re: Solid Edge Origin Help Needed
Posted by
Charles Gallo
on 2000-08-02 02:36:42 UTC
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
At 12:37 PM 2000-08-02 +0800, you wrote:
Thank you (all)
That was the tool I was looking for (pointed out to me Russ Rhoton) first,
and again by you. There is so much "stuff" in the program, that it's hard
to find what you need
Charlie
-----BEGIN PGP SIGNATURE-----
Version: PGPfreeware 6.5.2 for non-commercial use <http://www.pgp.com>
Comment: EMail NOT valid unless it is signed
iQA/AwUBOYfsAnrFNodJLHOCEQJy6ACg4wXhUYRXmDWpbsofq/p4M4EtayIAoJ9o
KOwh4NTt379BxIDfYTY7HYUD
=ePfa
-----END PGP SIGNATURE-----
Hash: SHA1
At 12:37 PM 2000-08-02 +0800, you wrote:
>Charles,<snip>
>first tip is the use the "plane" cross hairs, and to position / snap the
>center of the circle that becomes the shaft protrusion.
Thank you (all)
That was the tool I was looking for (pointed out to me Russ Rhoton) first,
and again by you. There is so much "stuff" in the program, that it's hard
to find what you need
Charlie
-----BEGIN PGP SIGNATURE-----
Version: PGPfreeware 6.5.2 for non-commercial use <http://www.pgp.com>
Comment: EMail NOT valid unless it is signed
iQA/AwUBOYfsAnrFNodJLHOCEQJy6ACg4wXhUYRXmDWpbsofq/p4M4EtayIAoJ9o
KOwh4NTt379BxIDfYTY7HYUD
=ePfa
-----END PGP SIGNATURE-----
Discussion Thread
Area51tats@a...
2000-07-30 19:36:52 UTC
Re: [CAD_CAM_EDM_DRO] cad/cam
johndroc@a...
2000-07-30 20:31:04 UTC
Re: [CAD_CAM_EDM_DRO] cad/cam
Area51tats@a...
2000-07-31 13:31:55 UTC
Re: [CAD_CAM_EDM_DRO] cad/cam
Doug Harrison
2000-07-31 14:14:50 UTC
Re: [CAD_CAM_EDM_DRO] cad/cam
john@m...
2000-07-31 15:08:28 UTC
Re: cad/cam
Charles Gallo
2000-07-31 17:58:12 UTC
Solid Edge Origin Help Needed
John Harnedy
2000-08-01 21:37:34 UTC
Re: Solid Edge Origin Help Needed
Charles Gallo
2000-08-02 02:36:42 UTC
Re: [CAD_CAM_EDM_DRO] Re: Solid Edge Origin Help Needed
Bill Griffin
2000-08-02 06:33:37 UTC
Re: Re: cad/cam
rekmac
2002-05-31 06:35:20 UTC
cad/cam