Re: I need some feedback on using wire rope for driving my x & y axis
Posted by
Arnie Minear
on 2007-12-11 07:17:15 UTC
Dave,
I was considering using a drum that would have 6 to 10 turns of the
rope around it. Then drive the drum with a stepper, either geared
down using a short timing belt, or I got an idea from CNC zone on
driving the drum using another several turns of wire rope around it
and then wrapped around a smaller shaft that would be coupled to the
stepper (sort of a wire rope reduction pulley). It is all sounding a
little to extensive to engineer correctly and hope to get satisfactory
results, I think I will go with ballscrews.
I will probably use wire rope to stabilize my X axis with a
rope/pulley combination to lock the two sides so they remain square to
each other, rather than drive each individually. This is where you
tie the linear slide in an X pattern.
Thanks everyone for the helpful feedback.
Arnie
I was considering using a drum that would have 6 to 10 turns of the
rope around it. Then drive the drum with a stepper, either geared
down using a short timing belt, or I got an idea from CNC zone on
driving the drum using another several turns of wire rope around it
and then wrapped around a smaller shaft that would be coupled to the
stepper (sort of a wire rope reduction pulley). It is all sounding a
little to extensive to engineer correctly and hope to get satisfactory
results, I think I will go with ballscrews.
I will probably use wire rope to stabilize my X axis with a
rope/pulley combination to lock the two sides so they remain square to
each other, rather than drive each individually. This is where you
tie the linear slide in an X pattern.
Thanks everyone for the helpful feedback.
Arnie
Discussion Thread
Arnie Minear
2007-12-10 08:08:48 UTC
I need some feedback on using wire rope for driving my x & y axis
Mark Bingham
2007-12-10 13:03:54 UTC
Re: [CAD_CAM_EDM_DRO] I need some feedback on using wire rope for driving my x & y axis
Arnie Minear
2007-12-10 13:09:51 UTC
Re: I need some feedback on using wire rope for driving my x & y axis
Paul Kelly
2007-12-10 15:02:57 UTC
RE: [CAD_CAM_EDM_DRO] Re: I need some feedback on using wire rope for driving my x & y axis
Mark Bingham
2007-12-10 16:17:51 UTC
Re: [CAD_CAM_EDM_DRO] Re: I need some feedback on using wire rope for driving my x & y axis
David G. LeVine
2007-12-10 19:12:23 UTC
Re: [CAD_CAM_EDM_DRO] I need some feedback on using wire rope for driving my x & y axis
jeetendra_g10
2007-12-11 04:23:23 UTC
Re: I need some feedback on using wire rope for driving my x & y axis
turbulatordude
2007-12-11 05:21:10 UTC
Re: I need some feedback on using wire rope for driving my x & y axis
Arnie Minear
2007-12-11 07:17:15 UTC
Re: I need some feedback on using wire rope for driving my x & y axis
turbulatordude
2007-12-12 06:41:05 UTC
Re: I need some feedback on using wire rope for driving my x & y axis