Re: lexmark 3d printer is back (binder & build matl)

Fogassa,
Congratulations but your are much to generous. You did all the work
and proved it could really be done. Out of the 3 of us that started
you were the one to cross the finish line and I will follow in your
footsteps using one of the older HP's with a HP45 cartridge.

I think there is an easier way to do the slicing than what I did with
VB.net and GDI. The Candyfab people at mad scientist
(http://www.evilmadscientist.com/article.php/slicingstl) are doing it
using some off the shelf free stuff with manual editing of VRML
scripts. Their approach does not rely on Rhino. I will be gone for a
week but when I get back I will look at streamlining and automating
the process.

Roger

> Not really, without Roger's help with the software I would not even
> start on this, so 50% of the credits goes to him.
> Thank's Roger!
>
> Fogassa.
>