CAD CAM EDM DRO - Yahoo Group Archive

Ref: circular saw spindle ?

Posted by stan
on 2008-04-06 08:09:08 UTC
> > > Hi all,
> > >
> > > anyone have plans for a circular saw spindle ?
> > >
> > > or attaching a circular saw to a Z axis ?
> > >
> > > Dave

Gaffa tape and jubilee clips :)
Most 4th axis/rotary tables could be adapted to do the job but you would have
to make it very high to get the center of the blade under the center of the
axis or do lots of really big sums to get correct alignment if it's offset.
Had you tried those roto-zip rotary saw things? I was using them on steel in a
dremel before I knew what they where for, god knows how much it got through
but it was still sharp after weeks of use. Not sure how accurate deep cuts
would be though, I don't think it would have a problem cutting through 2
inches of timber but it could be a bit wobbly at the bottom.
cheers

Discussion Thread

turbulatordude 2008-04-06 06:21:10 UTC circular saw spindle ? Jack McKie 2008-04-06 07:00:35 UTC Re: [CAD_CAM_EDM_DRO] circular saw spindle ? turbulatordude 2008-04-06 07:03:39 UTC Re: circular saw spindle ? Jack McKie 2008-04-06 07:08:03 UTC Re: [CAD_CAM_EDM_DRO] Re: circular saw spindle ? Michael Fagan 2008-04-06 07:56:58 UTC Re: [CAD_CAM_EDM_DRO] Re: circular saw spindle ? stan 2008-04-06 08:09:08 UTC Ref: circular saw spindle ? Jack McKie 2008-04-06 08:09:45 UTC Re: [CAD_CAM_EDM_DRO] Re: circular saw spindle ?