RE: [CAD_CAM_EDM_DRO] AHHA gone, what next
Posted by
shawn c
on 2008-11-04 13:07:47 UTC
Mach3 will likely be your best bet. Quite a few people have done it. I would check the mach group and search through past post. If memory serves there is an adapter plug in the files section (or somewhere) and a Mach configuration for the ahha already setup. I've seen plenty of post throughout the years dealing with the mach to ahha upgrade, join the mach group and do a little poking around or ask questions.
Shawn
To: CAD_CAM_EDM_DRO@yahoogroups.comFrom: bfairey@...: Tue, 4 Nov 2008 13:49:57 +0000Subject: [CAD_CAM_EDM_DRO] AHHA gone, what next
I thought that Mach3 would do the trick but althougth it is verypowerful it is tricky to set up. Anyone have any suggestions for a CNCprogram for a 3 axis mill.Brian Fairey.
[Non-text portions of this message have been removed]
Shawn
To: CAD_CAM_EDM_DRO@yahoogroups.comFrom: bfairey@...: Tue, 4 Nov 2008 13:49:57 +0000Subject: [CAD_CAM_EDM_DRO] AHHA gone, what next
I thought that Mach3 would do the trick but althougth it is verypowerful it is tricky to set up. Anyone have any suggestions for a CNCprogram for a 3 axis mill.Brian Fairey.
[Non-text portions of this message have been removed]
Discussion Thread
Brian Fairey
2008-11-04 05:53:26 UTC
AHHA gone, what next
Jack McKie
2008-11-04 06:34:21 UTC
Re: [CAD_CAM_EDM_DRO] AHHA gone, what next
Stephen Wille Padnos
2008-11-04 09:14:30 UTC
Re: [CAD_CAM_EDM_DRO] AHHA gone, what next
wildhorsesoftware
2008-11-04 11:12:29 UTC
Re: AHHA gone, what next
shawn c
2008-11-04 13:07:47 UTC
RE: [CAD_CAM_EDM_DRO] AHHA gone, what next
azdlb
2008-11-06 07:48:47 UTC
Re: AHHA gone, what next