RE: [CAD_CAM_EDM_DRO] electrical help wanted
Posted by
Dave Fisher
on 2008-12-26 17:34:21 UTC
I do presume you are using a diode / bridge rec etc to get the DC you need.
100 Volt caps would be ideal for this setup and as you rightly say the more
uf the better !
No need for the resistor setup you speak of as the amps should compensate
for small ripple etc
rgds
Dave
_____
From: CAD_CAM_EDM_DRO@yahoogroups.com
[mailto:CAD_CAM_EDM_DRO@yahoogroups.com] On Behalf Of Brian Fairey
Sent: 26 December 2008 15:18
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] electrical help wanted
Designing a PS for Gecko drivers.
The transformer gives out 50-0-50 what size capacitor should I use ?
ie 50v rating or 100v and the bigger the capacitance the better or what?
I remember in the OLD days that one put a capacitor across the output
then a resistor inline and another capacitor across the output. I
suspect this was great for the ripple effect but perhaps the Gecko
dont care.
Brian Fairey.
[Non-text portions of this message have been removed]
100 Volt caps would be ideal for this setup and as you rightly say the more
uf the better !
No need for the resistor setup you speak of as the amps should compensate
for small ripple etc
rgds
Dave
_____
From: CAD_CAM_EDM_DRO@yahoogroups.com
[mailto:CAD_CAM_EDM_DRO@yahoogroups.com] On Behalf Of Brian Fairey
Sent: 26 December 2008 15:18
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] electrical help wanted
Designing a PS for Gecko drivers.
The transformer gives out 50-0-50 what size capacitor should I use ?
ie 50v rating or 100v and the bigger the capacitance the better or what?
I remember in the OLD days that one put a capacitor across the output
then a resistor inline and another capacitor across the output. I
suspect this was great for the ripple effect but perhaps the Gecko
dont care.
Brian Fairey.
[Non-text portions of this message have been removed]
Discussion Thread
Brian Fairey
2008-12-26 07:18:37 UTC
electrical help wanted
Jon Elson
2008-12-26 10:35:51 UTC
Re: [CAD_CAM_EDM_DRO] electrical help wanted
Nigel F Misso
2008-12-26 11:26:03 UTC
Re: [CAD_CAM_EDM_DRO] electrical help wanted
Roland Jollivet
2008-12-26 12:02:41 UTC
Re: [CAD_CAM_EDM_DRO] electrical help wanted
Hugh Prescott
2008-12-26 17:30:15 UTC
Re: [CAD_CAM_EDM_DRO] electrical help wanted
Dave Fisher
2008-12-26 17:34:21 UTC
RE: [CAD_CAM_EDM_DRO] electrical help wanted
JanRwl@A...
2008-12-26 21:47:32 UTC
Re: [CAD_CAM_EDM_DRO] electrical help wanted
Paul Kelly
2008-12-27 00:43:06 UTC
RE: [CAD_CAM_EDM_DRO] electrical help wanted
Steve Blackmore
2008-12-27 02:02:21 UTC
Re: [CAD_CAM_EDM_DRO] electrical help wanted