Re: Goldmine servos and Sherline

--- In CAD_CAM_EDM_DRO@egroups.com, Ron Ginger <ginger@s...> wrote:

> I used one of the Goldmine $4.95 servos to try out my gekodrive

modules,

> and they seem rather powerful. Very scientific test- I tried to

grab the

> shaft while it was turning. Anyone tried to do any useful work with
> these? would they run a Sherline?
>
> what is the number of steps per rev?
>
> I would have to build a new coupling and mounting bracket, but I may
> give it a try. Sure would be a cheap solution if it works.
>

Ron,
I believe these are 400 counts per rev.
Can't say for sure as I have ordered 6 of these on the 21st of July
and according to Goldmines tracking system they are still
unfullfilled tonight, doesn't look promising.