Re: [CAD_CAM_EDM_DRO] Re: Goldmine servos and Sherline
Posted by
A. G. Eckstein
on 2000-08-07 15:19:20 UTC
I believe I remember seeing the documentation at some point indicating
these servos are 500 count per revolution. That is why I went with the
"cheaper" 3.95 units for the encoders with 1000 count per rev. I believe
they both use the HP quadrature encoder which has been well discussed in
this group.
Art
At 07:35 PM 8/7/00 -0000, you wrote:
Country Bubba
(Actually the inventor of Country and Bubba)
axtein@...
these servos are 500 count per revolution. That is why I went with the
"cheaper" 3.95 units for the encoders with 1000 count per rev. I believe
they both use the HP quadrature encoder which has been well discussed in
this group.
Art
At 07:35 PM 8/7/00 -0000, you wrote:
>--- In CAD_CAM_EDM_DRO@egroups.com, Ron Ginger <ginger@s...> wrote:OLDER THAN DIRT
>> I used one of the Goldmine $4.95 servos to try out my gekodrive
>modules,
>> and they seem rather powerful. Very scientific test- I tried to
>grab the
>> shaft while it was turning. Anyone tried to do any useful work with
>> these? would they run a Sherline?
>>
>> what is the number of steps per rev?
>>
>> I would have to build a new coupling and mounting bracket, but I may
>> give it a try. Sure would be a cheap solution if it works.
>>
> Ron,
>I believe these are 400 counts per rev.
>Can't say for sure as I have ordered 6 of these on the 21st of July
>and according to Goldmines tracking system they are still
>unfullfilled tonight, doesn't look promising.
Country Bubba
(Actually the inventor of Country and Bubba)
axtein@...
Discussion Thread
Ron Ginger
2000-08-07 12:12:40 UTC
Goldmine servos and Sherline
john@m...
2000-08-07 12:35:57 UTC
Re: Goldmine servos and Sherline
John D. Guenther
2000-08-07 12:36:22 UTC
Re: Goldmine servos and Sherline
John D. Guenther
2000-08-07 12:41:41 UTC
Re: Goldmine servos and Sherline
A. G. Eckstein
2000-08-07 15:19:20 UTC
Re: [CAD_CAM_EDM_DRO] Re: Goldmine servos and Sherline
Tim Goldstein
2000-08-16 21:25:25 UTC
A new CNC controller software for WIN 9X
John Stevenson
2000-08-17 00:37:36 UTC
A new CNC controller software for WIN 9X