CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Jack's Router Build

on 2009-04-21 10:41:52 UTC
Great progress !
You have isolated the prob to the a axis chain ie drive/motor/wiring etc.

BTW - Thus it is not the pfd !

Steppers very rarely are bad or go bad.
Cabling, connectors etc...
Swap x and a ... whats the result ?


Jack McKie wrote:
>
>
> Hanermo,
>
> The X motor runs fine at 300 but the A motor just sits there and
> hums. Bad motor???
>
> Thanks,
>
> Jack
>
> --
>

Discussion Thread

Jack Mc Kie 2009-04-21 04:59:29 UTC Jack's Router Build gcode fi (hanermo) 2009-04-21 05:06:45 UTC Re: [CAD_CAM_EDM_DRO] Jack's Router Build Jack McKie 2009-04-21 05:32:52 UTC Re: [CAD_CAM_EDM_DRO] Jack's Router Build gcode fi (hanermo) 2009-04-21 07:07:26 UTC Re: [CAD_CAM_EDM_DRO] Jack's Router Build Jack McKie 2009-04-21 09:48:42 UTC Re: [CAD_CAM_EDM_DRO] Jack's Router Build gcode fi (hanermo) 2009-04-21 10:41:52 UTC Re: [CAD_CAM_EDM_DRO] Jack's Router Build Jack McKie 2009-04-21 10:52:59 UTC Re: [CAD_CAM_EDM_DRO] Jack's Router Build