Re: [DIY-CNC] need transmission ideas / advice re: gantry
Posted by
stan
on 2009-05-12 02:04:44 UTC
Also, it would cost a lot less to get a starter motor re-wound to the voltage
and duty you are looking for than to source a DC motor directly. Obviously
this depends on the physical size of the motor, for the kind of output you
need it would be in the larger truck starter range. Any decent
starter/alternator specialist should be able to do this.
Only just thought of it, sorry for bulking out the thread.
Cheers
and duty you are looking for than to source a DC motor directly. Obviously
this depends on the physical size of the motor, for the kind of output you
need it would be in the larger truck starter range. Any decent
starter/alternator specialist should be able to do this.
Only just thought of it, sorry for bulking out the thread.
Cheers
Discussion Thread
gcode fi (hanermo)
2009-05-11 11:54:36 UTC
Re: [DIY-CNC] need transmission ideas / advice re: gantry
Bob Muse
2009-05-11 12:03:53 UTC
Re: [CAD_CAM_EDM_DRO] Re: [DIY-CNC] need transmission ideas / advice re: gantry
kabowers@N...
2009-05-11 14:55:45 UTC
Re: [CAD_CAM_EDM_DRO] Re: [DIY-CNC] need transmission ideas / advice re: gantry
Roland Jollivet
2009-05-11 18:08:35 UTC
Re: [CAD_CAM_EDM_DRO] Re: [DIY-CNC] need transmission ideas / advice re: gantry
Danny Miller
2009-05-11 22:54:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: [DIY-CNC] need transmission ideas / advice re: gantry
Danny Miller
2009-05-11 22:55:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: [DIY-CNC] need transmission ideas / advice re: gantry
gcode fi (hanermo)
2009-05-12 00:16:45 UTC
Re: [CAD_CAM_EDM_DRO] Re: [DIY-CNC] need transmission ideas / advice re: gantry
Danny Miller
2009-05-12 01:19:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: [DIY-CNC] need transmission ideas / advice re: gantry
stan
2009-05-12 01:49:21 UTC
Re: [DIY-CNC] need transmission ideas / advice re: gantry
stan
2009-05-12 02:04:44 UTC
Re: [DIY-CNC] need transmission ideas / advice re: gantry
gcode fi (hanermo)
2009-05-12 12:07:40 UTC
Re: [CAD_CAM_EDM_DRO] Re: [DIY-CNC] need transmission ideas / advice re: gantry
gcode fi (hanermo)
2009-05-12 12:11:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: [DIY-CNC] need transmission ideas / advice re: gantry
Danny Miller
2009-05-12 15:22:43 UTC
Re: [CAD_CAM_EDM_DRO] Re: [DIY-CNC] need transmission ideas / advice re: gantry