Re: [CAD_CAM_EDM_DRO] Motor heat

Thanks Tim I will check out the specs .... should have been done.
Jim

----- Original Message -----
From: Tim Goldstein <timg@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Thursday, August 10, 2000 6:24 PM
Subject: RE: [CAD_CAM_EDM_DRO] Motor heat


> If it is a stepper they frequently have a plate rating for max temp
or temp
> rise. I have some superior units that have a plate rating of 200 deg
F on
> the end bell and some vexa units that are rated for an 85 deg C temp
rise.
> Personally I get concerned when the motors are hotter than I want to
hold,
> but according to the specs I am just chicken on this point.
>
> Tim
> [Denver, CO]
>
> > Mariss
> > I meant to say how hot is to hot on a 23 motor?
> > Jim
> >
>
> --------------------------------------------------------------------
<e|-
> GET A NEXTCARD VISA, in 30 seconds! Get rates
> of 2.9% Intro or 9.9% Ongoing APR* and no annual fee!
> Apply NOW!
> http://click.egroups.com/1/7872/4/_/423600/_/965949692/
> --------------------------------------------------------------------
|e>-
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>