Re: [CAD_CAM_EDM_DRO] Servo motor
Posted by
ptengin@a...
on 2000-08-12 09:43:18 UTC
In a message dated 8/11/00 3:22:17 PM Hawaiian Standard Time,
jtregister@... writes:
<< >I found a surplus servomotor yesterday. Approx. 7" dia, 24" long,
Jim >>
Would not be an ideal setup but could be a real nice spindle motor? You could
do indexing etc. Hardinge lathe with one of those could make all sorts of
neat parts!!!! With live tooling on the cross slide, one could drill cross
holes, off center holes or mill flats, slots etc. Milling spirals would not
be hard.......
Peter
THRD, Inc.
jtregister@... writes:
<< >I found a surplus servomotor yesterday. Approx. 7" dia, 24" long,
>probably weighs70 lbs. , label is Kollmorgan.Now, as to how you would use the motor you found - I'm at a loss.
>rated 40 ft-lb torque at speed (1600 rpm) and 120 at stall with approx
>equalvalent current inputs in A.
Jim >>
Would not be an ideal setup but could be a real nice spindle motor? You could
do indexing etc. Hardinge lathe with one of those could make all sorts of
neat parts!!!! With live tooling on the cross slide, one could drill cross
holes, off center holes or mill flats, slots etc. Milling spirals would not
be hard.......
Peter
THRD, Inc.
Discussion Thread
dave engvall
2000-08-09 07:36:14 UTC
Servo motor
Jim Register
2000-08-11 18:21:22 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor
ptengin@a...
2000-08-12 09:43:18 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor
dave engvall
2000-08-12 22:41:48 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor
ptengin@a...
2000-08-13 01:58:37 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor
afogassa
2002-06-15 17:00:54 UTC
Servo motor
Jon Elson
2002-06-15 23:43:41 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor