Re: [CAD_CAM_EDM_DRO] Servo motor
Posted by
ptengin@a...
on 2000-08-13 01:58:37 UTC
In a message dated 08/12/2000 7:42:38 PM Hawaiian Standard Time,
dengvall@... writes:
<< << >I found a surplus servomotor yesterday. Approx. 7" dia, 24" long,
spindle motor with brake would have some advantages. Also
thought about using it for y axis drive on mill where the y axis weighs
several hundred lbs and needs some serious power for
acceleration.
Dave >>
Dave,
If your mill has a real heavy table/knee ( say series 2 Bp ) doing z axis
duty, you may need a large motor. Not as big as the one you scored perhaps
but larger than a Nema 23 ;)
Peter
THRD, Inc.
dengvall@... writes:
<< << >I found a surplus servomotor yesterday. Approx. 7" dia, 24" long,
> >probably weighs70 lbs. , label is Kollmorgan.could
> >rated 40 ft-lb torque at speed (1600 rpm) and 120 at stall with approx
> >equalvalent current inputs in A.
>
> Now, as to how you would use the motor you found - I'm at a loss.
>
> Jim >>
>
> Would not be an ideal setup but could be a real nice spindle motor? You
> do indexing etc. Hardinge lathe with one of those could make all sorts ofThe thought crossed my mind of using it for a spindle motor. A servoed
> neat parts!!!! With live tooling on the cross slide, one could drill cross
> holes, off center holes or mill flats, slots etc. Milling spirals would not
> be hard.......
>
> Peter
> THRD, Inc.
spindle motor with brake would have some advantages. Also
thought about using it for y axis drive on mill where the y axis weighs
several hundred lbs and needs some serious power for
acceleration.
Dave >>
Dave,
If your mill has a real heavy table/knee ( say series 2 Bp ) doing z axis
duty, you may need a large motor. Not as big as the one you scored perhaps
but larger than a Nema 23 ;)
Peter
THRD, Inc.
Discussion Thread
dave engvall
2000-08-09 07:36:14 UTC
Servo motor
Jim Register
2000-08-11 18:21:22 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor
ptengin@a...
2000-08-12 09:43:18 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor
dave engvall
2000-08-12 22:41:48 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor
ptengin@a...
2000-08-13 01:58:37 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor
afogassa
2002-06-15 17:00:54 UTC
Servo motor
Jon Elson
2002-06-15 23:43:41 UTC
Re: [CAD_CAM_EDM_DRO] Servo motor