Re: [CAD_CAM_EDM_DRO] OT, Prusa Mendle page4 posted
Posted by
Ron Thompson
on 2011-10-11 05:47:36 UTC
On 10/11/2011 8:28 AM, Kevin Martin wrote:
are, so that is not an option. I did it as you describe.
One possible fix would be to redesign it to rotate the stepper 45 degrees.
I think Adrians mounting will allow the big gear to be removed from the
shaft, but I'd have to look again to be sure.
--
Ron Thompson
On the Beautiful Florida Space Coast, right beside the Kennedy Space Center, USA
Will write HTML for ad clicks.
http://www.ourcadguy.com/
http://www.plansandprojects.com My hobby pages are here:
http://www.plansandprojects.com/My%20Machines/
Visit the castinghobby FAQ:
http://castinghobbyfaq.bareboogerhost.com/
[Non-text portions of this message have been removed]
>No, they don't line up. The holes would have to be where the gear teeth
> Ron,
> Did the holes in the big gear on the extruder allow you to tighten the
> motor mounting screws with the big gear in place?
> Our Wade's Extruder had a solid big gear, so we had to put in the
> drive shaft, adjust the gear mesh, snug the two back motor screws only
> (the other two were covered by the big gear), remove the drive shaft,
> tighten all the motor screws, and finally re-install the drive shaft.
> One of our complaints about our Wade's Extruder was that essentially
> to take any of it apart (or remove it from the X carriage on the
> printer) we pretty much had to take *all* of it apart.
>
> It looks like the holes in the big gear help solve part of this problem.
>
> -Kevin Martin
> the Papertrail Handmade Paper & Book Arts
> New Dundee, Ontario
> 518-884-7123
> www.papertrail.ca
>
are, so that is not an option. I did it as you describe.
One possible fix would be to redesign it to rotate the stepper 45 degrees.
I think Adrians mounting will allow the big gear to be removed from the
shaft, but I'd have to look again to be sure.
--
Ron Thompson
On the Beautiful Florida Space Coast, right beside the Kennedy Space Center, USA
Will write HTML for ad clicks.
http://www.ourcadguy.com/
http://www.plansandprojects.com My hobby pages are here:
http://www.plansandprojects.com/My%20Machines/
Visit the castinghobby FAQ:
http://castinghobbyfaq.bareboogerhost.com/
[Non-text portions of this message have been removed]
Discussion Thread
Ron Thompson
2011-10-10 15:55:48 UTC
OT, Prusa Mendle page4 posted
Kevin Martin
2011-10-11 05:28:50 UTC
RE: [CAD_CAM_EDM_DRO] OT, Prusa Mendle page4 posted
Ron Thompson
2011-10-11 05:47:36 UTC
Re: [CAD_CAM_EDM_DRO] OT, Prusa Mendle page4 posted