Re: [CAD_CAM_EDM_DRO] are 3/4 shafts good for axis ?
Posted by
Les Newell
on 2012-04-19 07:19:32 UTC
Avoid unsupported round shafts if at all possible. They flex badly. Even
1" will flex a surprising amount.
Have you considered V groove bearings and rails? IM Service stock the
bearings and rails quite cheap
<http://www.cadcamcadcam.com/cncmachinecomponents.aspx>? As long as you
use wipers on the rails they work quite well.
Les
1" will flex a surprising amount.
Have you considered V groove bearings and rails? IM Service stock the
bearings and rails quite cheap
<http://www.cadcamcadcam.com/cncmachinecomponents.aspx>? As long as you
use wipers on the rails they work quite well.
Les
On 19/04/2012 14:45, turbulatordude wrote:
> Hi all,
>
> I am designing a wood router with a 18 inch wide X axis.
> it looks like 3/4 inch shafts will fit the design really well, floating, connected to the ends, not fully supported along the length.
>
> I plan on using a trim router and will do cutting in wood.
>
> Anyone have experience with 3/4 inch shafting ? I am on the fence between 1 inch and 3/4 inch.
>
> If I was planning on doing anything stronger, I would use linear shafting that would be fully supported along the length, but that would cost more than the rest of this machine !
>
> Suggestions and feedback welcome.
>
> Dave
>
>
Discussion Thread
turbulatordude
2012-04-19 06:45:30 UTC
are 3/4 shafts good for axis ?
Les Newell
2012-04-19 07:19:32 UTC
Re: [CAD_CAM_EDM_DRO] are 3/4 shafts good for axis ?
Tony Smith
2012-04-19 08:05:07 UTC
RE: [CAD_CAM_EDM_DRO] are 3/4 shafts good for axis ?
Brian Worth
2012-04-20 03:35:09 UTC
Re: [CAD_CAM_EDM_DRO] are 3/4 shafts good for axis ?
Roland Jollivet
2012-04-20 04:25:08 UTC
[CAD_CAM_EDM_DRO] are 3/4 shafts good for axis ?
jcc3inc
2012-04-20 07:01:06 UTC
Re: are 3/4 shafts good for axis ?
Chuck Merja
2012-04-20 10:28:30 UTC
RE: [CAD_CAM_EDM_DRO] Re: are 3/4 shafts good for axis ?
Jack
2012-04-20 11:07:00 UTC
Re: are 3/4 shafts good for axis ?
turbulatordude
2012-04-20 15:00:22 UTC
Re: are 3/4 shafts good for axis ?
Tony Smith
2012-04-20 17:10:23 UTC
RE: [CAD_CAM_EDM_DRO] Re: are 3/4 shafts good for axis ?
Roland Jollivet
2012-04-20 20:22:47 UTC
Re: [CAD_CAM_EDM_DRO] Re: are 3/4 shafts good for axis ?
Randy Abernathy
2012-04-21 06:41:06 UTC
RE: [CAD_CAM_EDM_DRO] are 3/4 shafts good for axis ?