Meshcam?
Posted by
Jack
on 2012-06-22 04:15:39 UTC
As a result of Mecsoft/Rhinocam getting greedy I am looking for a different CAM software. Mecsoft is going to start charging for an annual seat so I want to bail.
I have been looking at Mesh cam and will probably try the demo but am wondering if any group members are using meshcam on a routine basis to generate toolpaths for both 2.5D and 3D. Likes, dislikes, problems, compatibility with Mach3?
Sharing your experience and opinion based on actual use would be appreciated!
Jack
I have been looking at Mesh cam and will probably try the demo but am wondering if any group members are using meshcam on a routine basis to generate toolpaths for both 2.5D and 3D. Likes, dislikes, problems, compatibility with Mach3?
Sharing your experience and opinion based on actual use would be appreciated!
Jack
Discussion Thread
Jack
2012-06-22 04:15:39 UTC
Meshcam?
Ron Thompson
2012-06-22 04:46:57 UTC
Re: [CAD_CAM_EDM_DRO] Meshcam?
Jack McKie
2012-06-22 05:51:15 UTC
Re: [CAD_CAM_EDM_DRO] Meshcam?
xoethosox
2012-06-22 10:47:01 UTC
Re: Meshcam?
Jack McKie
2012-06-22 11:37:26 UTC
Re: [CAD_CAM_EDM_DRO] Re: Meshcam?