Re: [CAD_CAM_EDM_DRO] Meshcam?
Posted by
Jack McKie
on 2012-06-22 05:51:15 UTC
Ron,
I have Rhinocam basic but can't use it on a 64 bit machine with Rhino5 and won't upgrade to something that requires an annual fee. I am mainly interested in what users think of Meshcam.
Jack
From: Ron Thompson <ron@...>
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Friday, June 22, 2012 7:46 AM
Subject: Re: [CAD_CAM_EDM_DRO] Meshcam?
I have Rhinocam basic but can't use it on a 64 bit machine with Rhino5 and won't upgrade to something that requires an annual fee. I am mainly interested in what users think of Meshcam.
Jack
From: Ron Thompson <ron@...>
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Friday, June 22, 2012 7:46 AM
Subject: Re: [CAD_CAM_EDM_DRO] Meshcam?
On 6/22/2012 7:15 AM, Jack wrote:
> As a result of Mecsoft/Rhinocam getting greedy I am looking for a
> different CAM software. Mecsoft is going to start charging for an
> annual seat so I want to bail.
>
> I have been looking at Mesh cam and will probably try the demo but am
> wondering if any group members are using meshcam on a routine basis to
> generate toolpaths for both 2.5D and 3D. Likes, dislikes, problems,
> compatibility with Mach3?
>
> Sharing your experience and opinion based on actual use would be
> appreciated!
>
> Jack
I don't know about that, but freemill is totally free. I downloaded it
and was able to generate Gcode in just a few minutes.
http://www.mecsoft.com/freemill.shtml
--
Ron Thompson
On the Beautiful Florida Space Coast, right beside the Kennedy Space Center, USA
Think, Draw, Print. 3D printers ROCK!
http://www.plansandprojects.com/My%20Machines/PrusaMendel2012-1/
http://www.plansandprojects.com My hobby pages are here:
http://www.plansandprojects.com/My%20Machines/
Visit the castinghobby FAQ:
http://castinghobbyfaq.bareboogerhost.com/
[Non-text portions of this message have been removed]
Discussion Thread
Jack
2012-06-22 04:15:39 UTC
Meshcam?
Ron Thompson
2012-06-22 04:46:57 UTC
Re: [CAD_CAM_EDM_DRO] Meshcam?
Jack McKie
2012-06-22 05:51:15 UTC
Re: [CAD_CAM_EDM_DRO] Meshcam?
xoethosox
2012-06-22 10:47:01 UTC
Re: Meshcam?
Jack McKie
2012-06-22 11:37:26 UTC
Re: [CAD_CAM_EDM_DRO] Re: Meshcam?