Re: [CAD_CAM_EDM_DRO] Meshcam?

On 6/22/2012 7:15 AM, Jack wrote:

> As a result of Mecsoft/Rhinocam getting greedy I am looking for a
> different CAM software. Mecsoft is going to start charging for an
> annual seat so I want to bail.
>
> I have been looking at Mesh cam and will probably try the demo but am
> wondering if any group members are using meshcam on a routine basis to
> generate toolpaths for both 2.5D and 3D. Likes, dislikes, problems,
> compatibility with Mach3?
>
> Sharing your experience and opinion based on actual use would be
> appreciated!
>
> Jack

I don't know about that, but freemill is totally free. I downloaded it
and was able to generate Gcode in just a few minutes.
http://www.mecsoft.com/freemill.shtml

--


Ron Thompson
On the Beautiful Florida Space Coast, right beside the Kennedy Space Center, USA

Think, Draw, Print. 3D printers ROCK!

http://www.plansandprojects.com/My%20Machines/PrusaMendel2012-1/

http://www.plansandprojects.com My hobby pages are here:
http://www.plansandprojects.com/My%20Machines/

Visit the castinghobby FAQ:
http://castinghobbyfaq.bareboogerhost.com/