Re: [CAD_CAM_EDM_DRO] Problems in Timing Belt drive system in 6WD robot

Alan,

You need a limited slip deferential.

Check the hobby shops. I think they sell miniature Torsen (sp?)
differentials. Check online for the Dubro line of products. I've seen
them posted on Ebay before, too.

Let me know whether this suggestion helps.

Doug

On Jan 25, 2013 3:51 PM, "KM6VV" <KM6VV@...> wrote:

> **
>
>
> Sorry for the cross-posting,
>
> I'm having problems with the timing belt drive system in a 6WD robot I'm
> building for Robomagellan competition in the upcoming Robogames.
> (Mechanical design courtesy DPA).
>
> Pictures in LM forum:
>
> http://www.lynxmotion.net/viewtopic.php?f=9&t=7839&hilit=6WD&start=45
>
> There are a pair of DC servo motors, each driving a short (3") 037
> (3/8") .2" pitch timing belt from the 2nd level down to the first, 23:15
> ratio for a 1.33 speed increase. The motors are mounted on opposite ends
>
> On the first level are three short axles on each side of the 'bot,
> connected on 8" centers by the same timing belts, and 20 tooth pulleys.
> There are belt tensioners (4) between each pair of pulleys pressing
> down on the top of the belt. (I do remember hearing that the tensioner
> pulleys should be on the driven side of the pulley, so one pair is on
> the wrong side).
>
> The belt system appears to run fine in straight runs, grass, concrete,
> etc., even when moving quite fast. The problem arises when the 'bot
> starts to make a turn (more torque required). I start hearing loud
> "popping" sounds, which I take to be the belt(s) jumping teeth.
>
> I can't determine which belt(s) is jumping. Since I first observed
> (heard) the problem, I've strengthened up the bearing supports between
> the axles, made a better tensioning nut for the belt tensioners
> (idlers), and increased the tension on the upper drive belts as well.
> Specs say 3-4 oz at 3/64" deflection on the belts, although I don't have
> a way to accurately measure it. The belts "sing" when they run, like
> they are being "plucked", so I think they're pretty tight.
>
> The angle of the upper motor belt is about 50 degrees, and I haven't yet
> figured out a way to add a tensioner to it.
>
> Any ideas?
>
> Thanks!
>
> Alan KM6VV
>
>


[Non-text portions of this message have been removed]