CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Motorising a rotary table

Posted by Ralph Reese
on 2013-06-27 15:43:44 UTC
This is what I use.

http://www.sherline.com/8700pg.htm

Ralph

To: CAD_CAM_EDM_DRO@yahoogroups.com
From: roblineng@...
Date: Tue, 25 Jun 2013 22:08:07 +0000
Subject: [CAD_CAM_EDM_DRO] Motorising a rotary table


























I have a 400mm rotary table that I wish to mechanise and understand that I need to fit a servo motor to it. I would propose to mount the motor to the input shaft after removing the handwheel .



Doing the mechanical is not a problem for me and even the wiring if I know what to do. Please can anyone help me with information of what I need to buy and how to wire things up. The handwheel to table ratio is 40:1 and I need to be able to control the table rotation from zero to 5 rpm.



I envisage controlling the motor either from a switch or a foot pedal. It would be handy if the motor could cause the table to rotate once and then stop but this isn't vital.





Many thanks for any help that may be given.



Mike



















[Non-text portions of this message have been removed]

Discussion Thread

michael_s@y... 2013-06-27 14:22:42 UTC Motorising a rotary table Ralph Reese 2013-06-27 15:43:44 UTC RE: [CAD_CAM_EDM_DRO] Motorising a rotary table Dave Halliday 2013-06-27 21:39:03 UTC RE: [CAD_CAM_EDM_DRO] Motorising a rotary table Randall Wink 2013-06-28 05:10:25 UTC RE: [CAD_CAM_EDM_DRO] Motorising a rotary table Randy 2013-06-28 06:15:47 UTC RE: [CAD_CAM_EDM_DRO] Motorising a rotary table Malcolm Parker-Lisberg 2013-06-28 07:34:05 UTC Re: [CAD_CAM_EDM_DRO] Motorising a rotary table John Dammeyer 2013-06-28 08:09:07 UTC RE: [CAD_CAM_EDM_DRO] Motorising a rotary table John Dammeyer 2013-06-28 09:09:19 UTC RE: [CAD_CAM_EDM_DRO] Motorising a rotary table David G. LeVine 2013-06-28 13:05:03 UTC Re: [CAD_CAM_EDM_DRO] Motorising a rotary table Andy M 2013-06-29 12:08:02 UTC Re: [CAD_CAM_EDM_DRO] Motorising a rotary table Malcolm Parker-Lisberg 2013-07-06 11:45:38 UTC Re: [CAD_CAM_EDM_DRO] Motorising a rotary table