RE: [CAD_CAM_EDM_DRO] Pin out of Goldmine G9932

Try:
http://www.usdigital.com/pdf/HEDS%20Data%20Sheet.pdf
It has the pinouts for the HEDS.

If you want to just go on my say so here it is:
Red & Black on 2 wire set = motor armature
4 wire set = encoder
Black = ground
Red = +5 VDC
Yellow & Blue = quadrature outputs. If things are reading backwards swap
these 2

What are you hooking them to??

Tim
[Denver, CO]

>
> Howdy All! I just picked up some of these Goldmine G9932 motors w/
> encoder, and wondered if one of you could send me the encoder pin out? I
> could probably figure it out, but I only bought 3 and would hate to
> waste 2 of them on a "voyage of discovery". <G>
>
> Thanks
>
> Rick Dulas