Re: [CAD_CAM_EDM_DRO] Pin out of Goldmine G9932

Rick,
The encoder pinout is Red=+5v, Black=Ground, Blue and Yellow are the
quadrature phase outputs.

Good luck on your project.

Art
At 10:05 PM 8/25/00 -0500, you wrote:

>Howdy All! I just picked up some of these Goldmine G9932 motors w/
>encoder, and wondered if one of you could send me the encoder pin out? I
>could probably figure it out, but I only bought 3 and would hate to
>waste 2 of them on a "voyage of discovery". <G>
>
>Thanks
>
>Rick Dulas
>
>

OLDER THAN DIRT

Country Bubba

(Actually the inventor of Country and Bubba)

axtein@...