CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Wanting to load up linux

Posted by Hugh Prescott
on 2000-09-11 18:13:27 UTC
AMD 5x86 P75 equivlent to a Pentium 75 according to the advertizing
department.

I have loaded RH 5.0 and 5.2 on some unnaned motherboards. Mboards have PCI
and ISA connectors. I used Trident 8900D ISA video cards and the system
worked.

Never tried to patch to a real time kernal. Kind of a test to see if the RH
would load and run.

Hugh

----- Original Message -----
From: bfp <bfp@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Monday, September 11, 2000 7:47 PM
Subject: Re: [CAD_CAM_EDM_DRO] Wanting to load up linux


>
> the AMD 586 is a quad-clocked 486 clone (the Intel DX4 is actualy
> tripple-clocked)
> and the AMD chips are fully compatable with Intel's while the Cyrix ones
are
> not
> the K5 was the first of the AMD pentiums.
> I was running Linux (without EMC) on an AMD 486-120Mhz with 32megs ram for
> a while ,it ran fine but X was a little slugish, especialy running Tcl/Tk
> programs
> so I dont know how well it would work with EMC but go ahead and try it and
> let
> us know how it works out ,if nothing else you will gain some Linux
> experience
> from it
> last I looked a default workstation install of redhat 5.2 was about
350-400
> megs
> newer versions will probably take up a little more room for the same
options
> but
> should still be less than 720megs
>
> Brian
>
> > Jon the cpu is a AMD 586 133mhz It also has on it
> > 5X86-P75
> > AMD-X5-133ADZ
> > A 9848EDP
> > 3.45 VOLTS
> > I hope this helps .All this was a freebe from a friend
> > If I need bigger I will look for one
> > John

Discussion Thread

Jon Elson 2000-09-11 13:27:29 UTC Re: [CAD_CAM_EDM_DRO] Wanting to load up linux marble here 2000-09-11 16:44:34 UTC Re: [CAD_CAM_EDM_DRO] Wanting to load up linux bfp 2000-09-11 17:46:52 UTC Re: [CAD_CAM_EDM_DRO] Wanting to load up linux Hugh Prescott 2000-09-11 18:13:27 UTC Re: [CAD_CAM_EDM_DRO] Wanting to load up linux Tim Goldstein 2000-09-11 20:04:56 UTC RE: [CAD_CAM_EDM_DRO] Wanting to load up linux Jon Elson 2000-09-11 23:51:05 UTC Re: [CAD_CAM_EDM_DRO] Wanting to load up linux Jon Elson 2000-09-12 00:08:29 UTC Re: [CAD_CAM_EDM_DRO] Wanting to load up linux Ian Wright 2000-09-12 05:37:14 UTC Re: [CAD_CAM_EDM_DRO] Wanting to load up linux marble here 2000-09-12 19:56:43 UTC Re: [CAD_CAM_EDM_DRO] Wanting to load up linux