Re: [CAD_CAM_EDM_DRO] Digest Number 700

dave engvall wrote:

CORRECTION: http://www.ee.umd.edu/medlab/papers/robautforsem97/robautforsem97.html
should work....only change is nmd to umd

> Hi all again:
>
> Pics of an impressive hexapod. US made.
>
> Looks like a massive welding job not castings. Servo motors and ball screws.
>
> http://www.ee.nmd.edu/medlab/papers/robautforsem97/robautforsem97.html
>
> I also found a site where a stiffness analysis was done ... with the purpose of supporting an 8500 Kg. astronomical mirror.
> It apparently is capable of adequate stability in 10 m/s winds.
> Interesting.
>
> Dave
>
> p.s. both of these sites were found by using metacrawler in a search for "stewart platform".
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager