CAD CAM EDM DRO - Yahoo Group Archive

Re: semiconductor cross-reference

Posted by Lee Studley
on 2000-09-30 12:01:35 UTC
I forgot to mention NTE or ECG as a cross-reference source also.
Search for them at (www.google.com) or similar.

I've used MCM alot over the years for japanese transistors ie
2SDxxxx 2SAxxxx 2SBxxxxx 2SDxxxxx

Hope this helps.

-Lee

--- In CAD_CAM_EDM_DRO@egroups.com, "Lee Studley" <indigo_red@u...>
wrote:
>
> If I'm not mistaken, these are probably 2SC2751 and 2SC2320
> You can try mcm electronics on the web(http://www.i-mcm.com)
> Here's what I found there. You'll need to verify that these
> are correct
>
>
> C2751:
> 2SC2751 SUB ONLY - USE ITEM# 2SC3435 5A 120W BCE:
> 2SC3435 NEC TRANSISTOR MP-80 500V 15A 120W BCE ($5.06)
>
> C2320: (small to-92 3 leg)
> 2SC2320 MITSUBISHI TRANSISTOR TO-92 50V .2A .3W ECB ($0.43)
>
>
>
>
> --- In CAD_CAM_EDM_DRO@egroups.com, "Carey L. Culpepper"
<mr.c@b...>
> wrote:
> > Well, I blew up one of my Vexta five phase drivers yesterday on
my
> South
> > Bend conversion. Fortunately, it was right at the end of a finish
> cut. A
> > wire to the motor shorted out to ground(shrink wrap problem).
Lot's
> of
> > smoke-unhappy camper. It blew the tops right off of some
> transistors. I
> > had two other drives, later model both dead but not as dead(I
didn't
> > kill those two). I pulled them apart and scavenged a mosfet out
of
> one
> > and got one going. I am guessing that I can also get the other
> working
> > also but need to find replacement parts. The part in question is
> made by
> > NEC C2751 there is also a smaller K3XB number on it. Anyone have
a
> > cross reference book that can give me an obtainable part number,
if
> > there is one? I will attempt repair on the one I smoked
yesterday
> later
> > on. It has different parts.The transistor is C2320 with a 63E
> number
> at
> > the bottom.
> > Carey

Discussion Thread

Carey L. Culpepper 2000-09-30 10:39:38 UTC semiconductor cross-reference Lee Studley 2000-09-30 11:56:50 UTC Re: semiconductor cross-reference Lee Studley 2000-09-30 12:01:35 UTC Re: semiconductor cross-reference Carey L. Culpepper 2000-09-30 12:36:15 UTC Re: [CAD_CAM_EDM_DRO] Re: semiconductor cross-reference Lee Studley 2000-09-30 13:00:19 UTC Re: semiconductor cross-reference Jon Elson 2000-09-30 15:32:40 UTC Re: [CAD_CAM_EDM_DRO] semiconductor cross-reference Darrell 2000-09-30 16:18:21 UTC Re: [CAD_CAM_EDM_DRO] semiconductor cross-reference