Re: semiconductor cross-reference
Posted by
Lee Studley
on 2000-09-30 11:56:50 UTC
If I'm not mistaken, these are probably 2SC2751 and 2SC2320
You can try mcm electronics on the web(http://www.i-mcm.com)
Here's what I found there. You'll need to verify that these
are correct
C2751:
2SC2751 SUB ONLY - USE ITEM# 2SC3435 5A 120W BCE:
2SC3435 NEC TRANSISTOR MP-80 500V 15A 120W BCE ($5.06)
C2320: (small to-92 3 leg)
2SC2320 MITSUBISHI TRANSISTOR TO-92 50V .2A .3W ECB ($0.43)
--- In CAD_CAM_EDM_DRO@egroups.com, "Carey L. Culpepper" <mr.c@b...>
wrote:
at
You can try mcm electronics on the web(http://www.i-mcm.com)
Here's what I found there. You'll need to verify that these
are correct
C2751:
2SC2751 SUB ONLY - USE ITEM# 2SC3435 5A 120W BCE:
2SC3435 NEC TRANSISTOR MP-80 500V 15A 120W BCE ($5.06)
C2320: (small to-92 3 leg)
2SC2320 MITSUBISHI TRANSISTOR TO-92 50V .2A .3W ECB ($0.43)
--- In CAD_CAM_EDM_DRO@egroups.com, "Carey L. Culpepper" <mr.c@b...>
wrote:
> Well, I blew up one of my Vexta five phase drivers yesterday on mySouth
> Bend conversion. Fortunately, it was right at the end of a finishcut. A
> wire to the motor shorted out to ground(shrink wrap problem). Lot'sof
> smoke-unhappy camper. It blew the tops right off of sometransistors. I
> had two other drives, later model both dead but not as dead(I didn'tone
> kill those two). I pulled them apart and scavenged a mosfet out of
> and got one going. I am guessing that I can also get the otherworking
> also but need to find replacement parts. The part in question ismade by
> NEC C2751 there is also a smaller K3XB number on it. Anyone have alater
> cross reference book that can give me an obtainable part number, if
> there is one? I will attempt repair on the one I smoked yesterday
> on. It has different parts.The transistor is C2320 with a 63Enumber
at
> the bottom.
> Carey
Discussion Thread
Carey L. Culpepper
2000-09-30 10:39:38 UTC
semiconductor cross-reference
Lee Studley
2000-09-30 11:56:50 UTC
Re: semiconductor cross-reference
Lee Studley
2000-09-30 12:01:35 UTC
Re: semiconductor cross-reference
Carey L. Culpepper
2000-09-30 12:36:15 UTC
Re: [CAD_CAM_EDM_DRO] Re: semiconductor cross-reference
Lee Studley
2000-09-30 13:00:19 UTC
Re: semiconductor cross-reference
Jon Elson
2000-09-30 15:32:40 UTC
Re: [CAD_CAM_EDM_DRO] semiconductor cross-reference
Darrell
2000-09-30 16:18:21 UTC
Re: [CAD_CAM_EDM_DRO] semiconductor cross-reference