RE: Milling Materials

If you decide to go with polycarbonate, you will want to make sure that you
get the cast variety, not the extruded stuff. The extruded stuff is
difficult to cut cleanly. The cast stuff cuts very nicely!

You may also want to look at the vfontz program from Fred Smith if you are
going to engrave any amount of fancy text, its amazing!

bill griffin

>I thought about plexiglass, but the materials I could find in my hardware
>store really didn't match my needs, I whould like to make the coins about
>3/8 of an inch thick, and with some weight.
>I haven't looked into either delrin or nylon, I'm going to have to find an
>industrial plastic supply house.

Snip