CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] DC servo motor

Posted by Tim Goldstein
on 2000-10-04 15:47:41 UTC
Give it a DC source and it will run just fine. Sort of a waste of a nice
motor, but if it on hand. . . .

Tim
[Denver, CO]


>
> Can I run a DC servo motor as a "regular" motor? Some have 2 leads
> and some 4. Some have obvious encoders, others I can't find evidence of
> an encoder.
> Thanks

Discussion Thread

Joe Vicars 2000-10-04 07:25:42 UTC DC servo motor eric 2000-10-04 07:42:18 UTC Re: [CAD_CAM_EDM_DRO] DC servo motor Tim Goldstein 2000-10-04 15:47:41 UTC RE: [CAD_CAM_EDM_DRO] DC servo motor Jon Elson 2000-10-04 23:38:18 UTC Re: [CAD_CAM_EDM_DRO] DC servo motor Dan Mauch 2000-10-05 05:41:53 UTC Re: [CAD_CAM_EDM_DRO] DC servo motor