Re: [CAD_CAM_EDM_DRO] Moglice Problem - Fixed?
Posted by
Joe Vicars
on 2000-10-12 09:41:46 UTC
Dan,
I just ordered a catalog from PIC. I hope they are easier and cheaper than "Stock Drive" or "Small Parts Inc."
Thanks
Dan Mauch wrote:
I just ordered a catalog from PIC. I hope they are easier and cheaper than "Stock Drive" or "Small Parts Inc."
Thanks
Dan Mauch wrote:
> Hmmm. A long time ago in a place far, far away I use to use various epoxy
> products for restoring fits and parts. In X-Y applications I think that the
> liquid products may not be cost effective. For one of the retrofits that I
> did, I used the turcite acme leadscrew power nuts from PIC Design
> 1-800-243-6125. A 5/8 10 thread power nut with virtually zero backlash is
> $14. A two piece antibacklash power nut is 22.50.
> They sell precision ground acme replacement leadscrews and power nuts from
> 3/16"Diameter to 5/8" and 4mm to 14 MM with various leads. I would think
> that it would be easier to buy one of their mounting brackets for $14 and a
> new turcite power nut for another $14 then fool around with trying to cast a
> precision drive nut. True that if you need a 3/4 " or larger drive nut then
> PIC could not provide a solution.
> My thoughts on the subject
> Dan
> -
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
Discussion Thread
Joe Vicars
2000-10-12 09:08:07 UTC
Moglice Problem - Fixed?
Dan Mauch
2000-10-12 09:27:01 UTC
Re: [CAD_CAM_EDM_DRO] Moglice Problem - Fixed?
Joe Vicars
2000-10-12 09:41:46 UTC
Re: [CAD_CAM_EDM_DRO] Moglice Problem - Fixed?
ballendo@y...
2000-10-12 13:54:35 UTC
re:Moglice Problem - Fixed?
ballendo@y...
2000-10-12 14:23:43 UTC
Re: Moglice Problem - Fixed?
ptengin@a...
2000-10-12 14:25:49 UTC
Re: [CAD_CAM_EDM_DRO] Moglice Problem - Fixed?
Anne Ogborn
2000-10-12 16:21:08 UTC
Re: [CAD_CAM_EDM_DRO] Moglice Problem - Fixed?
Kevin P. Martin
2000-10-13 07:08:57 UTC
RE: [CAD_CAM_EDM_DRO] re:Moglice Problem - Fixed?
ballendo@y...
2000-10-13 16:53:38 UTC
RE: re:Moglice Problem - Fixed?